However, let me remind you, the bus speed this chip runs at does not cause any issues. Now I know some of you who have dealt with AGND and DGND will tell me that I'm putting digital interference onto the analog ground plane. (The problem child) this *should be connected back directly from the 15 pin connector to its own* ground, but I was unable to solder a wire from the 15pin directly, so I soldered pin 2 to pin 1. ![]() Pin 12 and Pin 13, the -+USB data need to be connected to lower contact of the resistors directly above the 15 pin clip. ![]() Pin8 is another analog ground, this one needs to be connect to the GND side of one of the surface mount diodes to the right of the SST39VF010 chip. False, but in some scenarios, you cannot simultaneously use two devices with the same Bluetooth profile. You can hook up 7 devices, but only if theyre all different types of devices. This also takes care of Pin3,Pin10,Pin11,and Pin14 Pin4-pin7 are all vcc ,5 volt input, and can be connected to at a solder point directly to the left of the smaller "B" symbol next to the large 4716b diode(red wire). Copy the PS3 folder onto your USB device (don’t place it inside another folder on the flash drive or external hard drive). Mostly true - the standards only allow up to seven simultaneous connections on a normal device. Pin1 and pin15, analog ground, can be wired directly off of the 15pin connector, they have large contact points and are on top and bottom. ![]() Even taking a picture of the locations I used, seemed difficult. Unless your a god, or have some REALLY nice soldering equipment, you won't be able to solder directly off of the 15 pin connector, so we will have to find alternatives.
0 Comments
Leave a Reply. |